利用者:VenusBlanc900

Pull off the damaged thatch in the region you have to have to repair. You might possibly not have to get rid of an entire area, basically a few of the upper, damaged layers. Lay one layer of thatch bundle on the cleaned out area. Depending on the size of the repair, here, region you are able to need to use a lot more than 1 bundle per layer. Push the most effective of the bundle into the thatch above it.Make yet another layer of thatch on very best of the initial, attaching it with hazel sticks in the exact same way. The hazel will act for instance a hairpin and hold the thatch in location. You will need the old and new thatch to intermingle. Add as numerous layers as you need to until the new thatch is even using the old thatch. Roll up the old rolled roofing material and toss it aside. Slide the finest edge of the material up below the current rolled roofing.Apply further roofing tar to where the top edge of the material meets the present material. Apply roofing tar or cement towards the backside of the rolled roofing. Use a wooden stick to apply the roofing tar. There are 100 square feet in a roofing square, and this is how roofing measurements are taken. Fasten the felt paper towards the roof using the roofing stapler and staples. Cut the damaged section of paper cautiously, using the razor knife.Cut out about any cracked or peeling locations with a razor knife and eradicate both poor section. Slip a putty knife below the edges around the cutout location. Apply roofing cement under the edges. The roofing cement you might be working with will not stick if the surface is dirty.Pry the cut open and force roofing cement in both sides of the cut. Refer towards the roofing stapler owner's manual for operation and safety directions.